Juniper MX10008 Hardware Manual page 260

To install the cable management system (see
1. Open the shipping carton of the cable management system and check that you have:
Two handle extensions
One cable tray
Figure 153: Cable Management System Components
1 Handle extensions
—
2. Use the Phillips screwdriver to loosen and remove the screws on the two line card handles (see
Figure 154 on page 262).
Figure 154: Removing the Screws on the Line Card Handles
3. Replace the blue cap on each line card handle with the two handle extensions (see
Figure 155 on page 263).
Figure 153 on page 262):
2 Cable tray
—
262