Juniper MX10008 Hardware Manual page 225

17. Push the captive screw into the power supply faceplate. Ensure that the screw is seated inside the
corresponding hole on the faceplate.
18. Tighten the captive screw by turning it clockwise by using the Phillips (+) screwdriver, number 1. When
the screw is completely tight, the latch locks into the router chassis.
Figure 122: Installing a JNP10K-PWR-DC Power Supply in an MX10008
Figure 123: Installing a JNP10K-PWR-DC Power Supply in an MX10016
Keep latch in open position during installation.
Close latch after power
supply is fully installed.
227