Snmpv3 Trap Host Configuration - Lenovo CN4093 Application Manual

SNMPv3 Trap Host Configuration

© Copyright Lenovo 2015
To configure a user for SNMPv3 traps, you can choose to send the traps with both
privacy and authentication, with authentication only, or without privacy or
authentication.
This is configured in the access table using the following commands:
CN 4093(config)# snmp-server access <1-32> level
CN 4093(config)# snmp-server target-parameters <1-16>
Configure the user in the user table accordingly.
It is not necessary to configure the community table for SNMPv3 traps because the
community string is not used by SNMPv3.
The following example shows how to configure a SNMPv3 user v3trap with
authentication only:
CN 4093(config)# snmp-server user 11 name v3trap
CN 4093(config)# snmp-server user 11 authentication-protocol md5
authentication-password
Changing authentication password; validation required:
Enter current admin password:
Enter new authentication password:
Re-enter new authentication password: <auth. password>
New authentication password accepted.
CN 4093(config)# snmp-server access 11 notify-view iso
CN 4093(config)# snmp-server access 11 level authnopriv
CN 4093(config)# snmp-server group 11 user-name v3trap
CN 4093(config)# snmp-server group 11 tag v3trap
CN 4093(config)# snmp-server notify 11 name v3trap
CN 4093(config)# snmp-server notify 11 tag v3trap
CN 4093(config)# snmp-server target-address 11 name v3trap address
47.81.25.66
CN 4093(config)# snmp-server target-address 11 taglist v3trap
CN 4093(config)# snmp-server target-address 11 parameters-name v3param
CN 4093(config)# snmp-server target-parameters 11 name v3param
CN 4093(config)# snmp-server target-parameters 11 user-name v3trap
CN 4093(config)# snmp-server target-parameters 11 level authNoPriv
<admin. password>
<auth. password>
Chapter 36: Simple Network Management Protocol
543