Default Setup Options
1. Connect to the switch.
2. Enter USERID as the default administrator and PASSW0RD (with a zero) as the
3. Enter the following command at the prompt:
Stopping and Restarting Setup Manually
Stopping Setup
Restarting Setup
Setup Part 1: Basic System Configuration
1. Enter y if you will be configuring VLANs. Otherwise enter n.
48
CN4093 Application Guide for N/OS 8.2
The Setup prompt appears automatically whenever you login as the system
administrator under the factory default settings.
After connecting, the login prompt will appear as shown here.
Enter login username:
Enter login password:
default password.
CN4093(config)# setup
To abort the Setup utility, press <Ctrl‐C> during any Setup question. When you
abort Setup, the system will prompt:
Would you like to run from top again? [y/n]
Enter n to abort Setup, or y to restart the Setup program at the beginning.
You can restart the Setup utility manually at any time by entering the following
command at the administrator prompt:
CN4093(config)# setup
When Setup is started, the system prompts:
"Set Up" will walk you through the configuration of
System Date and Time, Spanning Tree, Port Speed/Mode,
VLANs, and IP interfaces. [type CtrlC to abort "Set Up"]
If you decide not to configure VLANs during this session, you can configure them
later using the configuration menus, or by restarting the Setup facility. For more
information on configuring VLANs, see the Lenovo N/OS Application Guide.
Next, the Setup utility prompts you to input basic system information.