Optics; Removing And Installing The Lens - Christie GS Series Service Manual

Optics

Learn how to replace optical components.

Removing and installing the lens

Warning! Failure to comply with the following could result in death or serious injury.
• Do not look into the projector lens when the laser is on. The extremely high brightness can cause
permanent eye damage.
Before installing the lens, if a lens plug is inserted in the opening of the projector, remove the plug
from the lens opening.
1. Center the lens.
a. Ensure the projector is on.
b. Ensure the lens is at or near its center position.
Attempting to remove the lens when at a large offset may cause damage to the lens
assembly.
c. To center the lens, press the Lens Horizontal or Lens Vertical button.
d. Press Enter.
2. Turn off the projector and disconnect it from AC power.
3. Remove the lens.
a. To remove the lens, press the Lens Release button and rotate the lens counterclockwise
by a quarter to release the lock.
b. Remove the lens through the front of the projector.
4. Install the new lens.
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
71