Replacing Fan 6 - Christie GS Series Service Manual

See Replacing the main board and I/O board
3. Remove the eight M3 screws securing the shielding.
4. Loosen the four captive M3 screws securing the fan modules (fan 7 and fan 5).
5. Replace the affected fan.
6. To re-install the fan modules, follow these steps in reverse order.

Replacing fan 6

To replace fan 6, complete the following steps.
1. Remove the front and rear LD banks.
See Replacing the front LD bank and rear LD bank
2. Remove the four M3 screws securing fan 6.
3. Replace fan 6.
4. To re-install, follow these steps in reverse order.
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
on page 78.
on page 77.
Ventilation and cooling
66