Replacing The Front Ld Bank And Rear Ld Bank - Christie GS Series Service Manual

Replacing the front LD bank and rear LD bank

Replacing the LD bank must be done in a clean room.
i
To remove the front laser driver (LD) bank and rear laser driver (LD) bank, complete the following
steps.
1. Remove the light engine, and combiner.
See Replacing the light engine, and combiner
2. Remove the screw with a Phillips Jewelers screwdriver securing thermal sensor.
3. Remove the four screws with a Phillips Jewelers screwdriver securing the front LD bank.
4. Remove the four screws with a Phillips Jewelers screwdriver securing the rear LD bank.
5. Replace the front LD bank and/or the rear LD bank.
6. To re-install, follow these steps in reverse order.
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
on page 73.
Optics
77