Service Guidelines; Ordering Parts; Replacing Modules; Servicing Live Equipment - Christie GS Series Service Manual

Service guidelines

Review safety guidelines and information required for replacing modules.

Ordering parts

When ordering replacement parts, quote the part numbers of the items required. Quote the
projector model number, serial number, and date of manufacture, as indicated on the license label.
Not all parts are available separately. In addition, some parts stocked as inventory are available
only until the current supply lasts.
All part numbers are subject-to-change.
i

Replacing modules

To ensure you have the correct module and the projector module is replaced correctly, check
module markings, parts lists, and the relevant disassembly and replacement procedures.
Components must be replaced with exact equivalents. Failure to do so may result in unsafe
operation.

Servicing live equipment

Only Christie accredited technicians who are knowledgeable about the hazards associated with
hazardous voltage, ultraviolet exposure, and high temperatures are authorized to assemble, install,
and service Christie equipment.
To make sure you remain safe when servicing energized (live) Christie equipment:
• Locate the main AC power shut off prior to servicing the equipment. This will allow you to turn
the power off quickly in an emergency.
• Disconnect the projector from the communication and management network so it cannot
receive commands to turn the lamp on, open the douser, and move the lens.
• Familiarize yourself with all potential safety hazards prior to servicing the equipment. This
includes, but is not limited to, the location and accessibility of hazardous voltages.
• Read and understand all written procedures prior to commencing a service procedure.
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
10