Christie GS Series Service Manual page 83

10. Remove the mylar.
11. Remove the three standoff screws with an M3 socket driver from the main board and lift off the
main board.
12. Remove the four M3 screws securing the shielding to the right cover.
13. Remove the five M3 screws securing the main board to the bottom shielding.
14. If replacing the main board, transfer the three standoff screws to the new board.
15. Replace the main board and/or the I/O board.
16. To re-install, follow these steps in reverse order.
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
Printed circuit boards and sensors
83