Removing The Bottom Cover - Christie GS Series Service Manual

4. Loosen the four captive M3 screws.
5. At both ends of the projector, remove the four M3 screws securing the left cover module.
6. To separate the interlock switch from the left-side cover, remove the two M3 screws.
7. Transfer the interlock switch to the new left-side cover.
8. Replace the left-side cover.
9. To re-install, follow these steps in reverse order.

Removing the bottom cover

To re ove the bottom cover
m
1. Remove all covers from the projector.
See Removing the top cover
front cover on page 58,
side cover on page 60.
2. Remove the main board and I/O board.
See Replacing the main board and I/O board
3. Remove fans 1, 2, 3, 5, and 7.
See Replacing fans 1, 2, and 3
4. Remove the power supply.
See Removing the power supply
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
complete the following steps.
,
on page 57, Removing the rear cover
Removing the right-side cover
on page 64 and
on page 68.
Projector covers and feet
on page 58,
on page 59, and
on page 78.
Replacing fans 5 and 7
Removing the
Removing the left-
on page 65.
61