Performing A Wireless Function Test - Christie GS Series Service Manual

1. Write down the projector IP.
a. Plug in the power cord to the projector.
b. Connect the PC and projector using a RJ45 cable.
c. Turn on the projector.
d. On the IR remote keypad, select Menu > Configuration > Communications > LAN.
e. Make sure DHCP is disabled.
f. Write down the following information:
• The IP address: 192.168.0.100 (default)
• The Subnet Mask: 255.255.255.0 (default)
2. In Network settings, set the projector IP address.
See Performing a network function test on the network port
3. Read the projector information.
See Performing a network function test on the network port
Performing a RS232 and video function test on
HDBaseT port
To perform the RS232 and video function test, complete the following steps.
1. Connect the CH-506TX, projector and PC as shown in step 5.
2. Select the signal source HDBaseT.
3. On the IR remote keypad, press Menu > Configuration > Communications> Serial port >
HDBaseT.
4. Set the PC Baud Rate to 115200.
5. Input the RS232 command (SYS?).
The projector returns (SYSx).
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
RJ45 to HDBaseT port
Power
on page 31.
on page 31.
RS232 to PC
HDMI input
Service setups
33