Replacing The Color Wheel - Christie GS Series Service Manual

a. Fully insert the lens assembly straight into the lens mount.
b. To lock the lens in place, rotate the lens cap clockwise.

Replacing the color wheel

Replacing the color wheel must be done in a clean room.
i
To remove the color wheel, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the HDMI extender board.
See Replacing the HDMI extender board
3. Remove the main board.
See Replacing the main board and I/O board
4. To disassemble the sealing cover, remove the rubber and five M3 screws.
5. To replace the color wheel module, remove the three M3 screws.
6. To re-install, follow these steps in reverse order.
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
on page 57.
on page 78.
on page 78.
Optics
72