Performing A Video Calibration - Christie GS Series Service Manual

After a few seconds, the ADC calibration status changes from Doing to Done.

Performing a video calibration

To perform the video calibration, complete the steps below.
ID Part name
1 Test equipment
2 Test signal
3 Test pattern
4 Inspection items
1. On the IR remote keypad, press Menu > Size & Position > Size Presets > Full Size.
2. Enter Factory mode.
See Entering Factory mode
3. Select ADC Calibration > Help.
After a few seconds, the ADC calibration status changes from Doing to Done.
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
Description
Video generator (output level: 700 mv)
• 1080P: Analog 1920 x 1080 @60Hz
• WUXGA: Analog 1920 x 1200 @60Hz
SMPTE BAR
Check if the ADC calibration status has changed from Doing to Done.
on page 13.
Service setups
19