Table of Contents
Advertisement
4. Equally turn the set screw (A) and cap screw (B) in opposite directions until the black corner is
removed.
5. If the black corner remains, insert a hex driver in the second set screw (C) and a hex driver in
the second cap screw (D).
6. Equally turn the set screw (C) and cap screw (D) in opposite directions until the black corner is
removed.
7. Replace the top cover.
Displaying a test pattern
Display a test pattern to refine and adjust the projected image or to diagnose and correct image
issues.
1. In the right toolbar, select Test Patterns.
2. Select Full Screen.
3. Select a test pattern.
When a test pattern is active, a blue bar appears below the test pattern icon in the right pane.
4. To display a 2D test pattern in 3D mode, select the 3D Sync option.
The 3D Sync option is selected automatically for 3D test patterns. 3D test patterns cannot be
displayed in 2D mode.
5. To change the frame rate of the test pattern display, select from the available Frame Rate
options:
•
For 2D test patterns, the available frame rates are 24, 30, 48, and 60 Frames Per Second
(FPS). The default value is 24 FPS.
•
For 3D test patterns, the available frame rates are 48 and 60 FPS. The default value is 48
FPS.
Changing the frame rate of the display can assist with color measurement when working with
corrected colors.
Cinema 2K-RBe Installation and Setup Guide–CP2406-RBe, CP2409-RBe, and CP2411-RBe
020-103907-01 Rev. 1 (03-2024)
Copyright
©
2024 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Adjusting the image
50
Advertisement
Table of Contents
