Completing A Picture In Picture/Picture By Picture Function Test; Performing A Network Function Test On The Network Port - Christie HS 2K Series Service Manual

To perform the USB A port performance test, complete the following steps.
1. Connect a U disk to the projector over the USB A port.
2. Switch the signal source to Card reader.
The data of U disk is projected.
Completing a picture in picture/picture by picture
function test
Always perform the picture in picture/picture by picture function test after repairing the main board,
or upgrading the scalar firmware. If the performance is not normal, replace the main board (see
Replacing the main board
1. On the IR remote keypad, press Menu > Input Switching&PIP > PIP/PBP Enable.
2. Set PIP/PBP Enable to On.
3. Ensure each item is functioning normally.
Performing a network function test on the
network port
The following browsers are supported for this test:
• Internet Explorer: IE8 for WinXP, IE9 or higher for Win7, and IE11 for Win8.1 or Win10 is
required.
• Chrome: Version 49 or higher is required.
• Firefox: Version 46 or higher is required.
• Safari: Not supported.
To perform the network function test, complete the following steps.
1. Record the projector IP address.
a. Plug in the power cord to the projector.
b. Connect PC and projector using a RJ45 cable.
c. Turn on the projector.
d. On the IR remote keypad, press Menu and select Configuration > Communications
> LAN.
e. Make sure DHCP is disabled.
f. Record the following information:
• The IP address: 192.168.0.100 (default)
• The Subnet Mask: 255.255.255.0 (default)
2. In Network settings, set the projector IP address.
HS Series 2K Service Manual—D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001468-02 Rev. 1 (01-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 94).
Service setups
35