Safety Measures In Normal Operation; Safety Inspection; Alterations - Fronius LaserHybrid Ultracompact Twin Operating Instructions Manual

Safety measures
in normal opera-
tion

Safety inspection

Alterations

16
When transporting the device, observe the relevant national and local guide-
lines and accident prevention regulations. This applies especially to guidelines
regarding the risks arising during transport.
Before transporting the device, allow coolant to drain completely and detach
the following components:
- Wire feed speed
- Wirespool
- Shielding gas cylinder
After transporting the device, the device must be visually inspected for dam-
age before commissioning. Any damage must be repaired by trained service
technicians before commissioning the device.
Only operate the LaserHybrid head if all protection and safety devices are fully
functional. If the safety devices are not fully functional, there is a risk of
- injury or death to the operator or a third party,
- damage to the device and other material assets belonging to the operator,
- inefficient operation of the device.
Any safety devices that are not functioning properly must be repaired before
switching on the device.
Never bypass or disable safety devices.
Before starting up the LaserHybrid head, ensure that no one is likely to be en-
dangered.
Check the LaserHybrid head at least once a week for obvious damage and
proper functioning of the safety devices.
The operator is obliged to have the LaserHybrid head checked by a qualified
electrician to ensure it is safe for use after any modifications, alterations, re-
pairs, care and maintenance, and in any case at least every twelve months.
Regulation
IEC (EN) 60 974-1
BGV A2, §5
BGV D1, §33 / §49
VDE 0701-1
VDE 0702-1
Do not carry out any modifications, alterations, etc. to the LaserHybrid head
without the manufacturer's consent.
Components that are not in perfect condition must be replaced immediately.
Title
Arc welding equipment - Part 1: Power sources
Electrical plant and equipment
Welding, cutting and associated processes
Repair, modification and inspection of electrical ap-
pliances;
general requirements
Repeat tests on electrical equipment