Safety Measures In Normal Operation; Maintenance And Repair; Safety Inspection - Fronius Robacta Reamer X-Line J Operating Instructions Manual

Safety Measures Only operate the device when all safety devices are fully functional. If the safety devices
in Normal Opera- are not fully functional, there is a risk of
tion -
-
-
Safety devices that are not fully functional must be repaired before the device is started
up.
Never bypass or disable safety devices.
Before starting up the device, ensure that no one can be put in danger.
The device must be examined at least once a week for externally detectable damage
and functionality of the safety devices.
-
-
-
-
-
Maintenance and It is impossible to guarantee that bought-in parts are designed and manufactured to meet
repair the demands made of them, or that they satisfy safety requirements.
-
-
-
-
The housing screws provide the ground conductor connection for earthing the housing
parts.
Only use original housing screws in the correct number and tightened to the specified
torque.

Safety Inspection

The manufacturer recommends that a safety inspection of the device be performed at
least every 12 months.
A safety inspection by a certified electrician is recommended:
-
-
-
-
For the safety inspection, follow the appropriate national and international standards and
guidelines.
You can obtain more information about the safety inspection and calibration from your
service center. The service center will provide the necessary documents upon request.
injury or death to the operator or a third party,
damage to the device and other material assets belonging to the operating com-
pany,
inefficient operation of the device.
Only use appropriate original parting agents from the manufacturer.
When handling parting agent, observe the information on the parting agent safety
data sheet. The parting agent safety data sheet can be obtained from your service
center or via the manufacturer's website.
Do not mix parting agents from the manufacturer with other parting agents.
If damage occurs due to the use of other parting agents, the manufacture is not
liable for this and all warranty claims are forfeited.
Properly dispose of used parting agent according to national and international regu-
lations.
Use only original spare and wearing parts (also applies to standard parts).
Do not carry out any modifications, alterations, etc. to the device without the manu-
facturer's consent.
Components that are not in perfect condition must be replaced immediately.
When ordering, please give the exact designation and part number as shown in the
spare parts list, as well as the serial number of your device.
after changes
after alterations
after repair, care, and maintenance
at least every 12 months.
9