Error Messages - Siemens SINUMERIK 840D sl Function Manual

①
②
③
④
⑤
⑥
14.6.4.15

Error messages

If a function could not be executed, the following signals are set depending on the error:
● DB390x .DBX3000.0 == 1 (axis cannot be started)
● DB390x.DBX3000.1 == 1 (error during travel)
The exact error cause is indicated as:
● DB390x.DBB3003 (error number)
Error number Meaning
Decimal Hex
1 01 Several functions of the axis/spindle were activated simultaneously
20 14 A function was started without the position being reached
30 1E The axis/spindle was transferred to the NC while still in motion
40 28 The axis is programmed by the NC program, NCK internal error
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Function activated by user with a positive edge of
Positioning axis active and Position reached are signaled back, Position reached is in
Signals
this case irrelevant.
The user stops spindle rotation by resetting
The spindle stops and the
Stop .
The user then resets
Stop causes Positioning axis active to be reset.
Reset of
Start .
Start and setting Stop .
Spindle stationary signal is set.
P4: PLC for SINUMERIK 828D
14.6 Function interface
1143