W1: Tool offset
18.2 Tool
18.2.3
Calculating the tool compensation
D No.
The D no. is sufficient for calculating the tool compensations (can be set via MD).
Programming
The above compensation block is to be calculated in the NC.
Part program call:
...
D
n
18.2.4
Address extension for NC addresses T and M
MD20096
Whether also with tool management not activated, the address extension of T and M is to be
interpreted as spindle number, can be set through the machine data:
MD20096 $MC_T_M_ADDRESS_EXT_IS_SPINO (spindle number as address extension).
The same rules then apply to the reference between the D number and T number as when the
"Tool management" function is active.
Effect on the D number
A compensation data set is determined by the D number.
The D address cannot be programmed with an address extension.
The evaluation of the D address always refers to the currently active tool.
1370
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Basic Functions