Program Test - Siemens SINUMERIK 840D sl Function Manual

W1: Tool offset
18.3 Flat D number structure
MD22560 $MC_TOOL_CHANGE_M_CODE (M function for tool change).
The default is M6. An address extension of M6 is interpreted as a spindle number.
Example
Two spindles are defined, spindle 1 and spindle 2, and the following applies:
MD20090 = 2
M6
M1 = 6
M2 = 6
18.3.6

Program test

MD20110
To have the active tool and the tool compensation included as follows, can be defined via the
machine data:
MD20110 $MC_RESET_MODE_MASK, Bit 3 (Definition of control default settings after
RESET/TP end).
Value
Bit 3
Prerequisite
The bits 0 and 6 must be set by the machine data:
MD20110 $MC_RESET_MODE_MASK, Bit 3 (Definition of control default settings after
RESET/TP end).
1386
; Spindle no. 2 is the master spindle.
; Tool change desired, command refers implicitly to the master spin-
dle
; No tool change, since spindle no. 2 is the master spindle
; Tool is changed, since spindle no. 2 is the master spindle
Significance
= 1 From the last test program to finish in test mode
= 0 From the last program to finish before activation of the program test
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Basic Functions