Setting Administrative Parameters - Siemens Sicam P855 7KG85 Series Device Manual

7 Operation at Use of a PC
7.3 Configuration of the Device
7.3.6

Setting Administrative Parameters

In the Configure tab you can view and if necessary edit the administrative settings. You can select the
parameters in the Administrative menu in the navigation window. These parameters can be changed in the
input/output windows Time synchronization, Communication Ethernet and Communication serial and
Device and language.
NOTE
Observe the procedure for the device configuration described in Device Configuration Procedure when setting
the administrative parameters.
7.3.6.1 Time Synchronization
Default Settings and Setting Ranges of the Time Synchronization
Table 7-19
Source time synchronization
Time zone offset to UTC
Daylight Saving Time switchover
DST offset
Start of DST
End of DST
Additional Parameters if the Source is Ethernet NTP (Modbus TCP and IEC 61850)
Primary NTP server IP address
Secondary NTP server IP address
Error indication after
Additional Parameter if the Source is Fieldbus (Modbus RTU and IEC 60870-5-103)
Error indication after
158
Time Synchronization Settings
Parameter Default Setting
Internal
+00:00
yes
+01:00
March
Last week
Sunday
02:00 AM
October
Last week
Sunday
03:00 AM
192.168.0.254
192.168.0.253
10 min
10 min
Setting Range
Internal
Ethernet NTP
Fieldbus
-12 to +13 (hours)
(in increments of 0.5 h)
no
yes
0 to + 2 (hours)
(in increments of 0.5 h)
Acc. to list boxes
(see Operating Parameters)
Acc. to list boxes
(see Operating Parameters)
Any
Any
No polling of the NTP server if
0.0.0.0 was entered
2 min to 120 min
2 min to 120 min
SICAM P850/P855, 7KG85xx, Device Manual
E50417-H1040-C482-A6, Edition 10.2018