Ports - VBrick dme Admin Manual

Ports

To access the Ports fields:

1. Navigate to
Field
RTSP Server Port
MPS Server Port
Multi-Protocol Server RTSP
port
RTMP Server Announce
Listener Port
VBAdmin Server Port
Conversion Input Port Start
Secure VBAdmin Server Port Default = 8383. Specifies the listener port for management
DME Admin Guide
>
System Configuration Ports
Description
Default = 554. RTSP port for VOD streams from RTP
server. Cannot be changed. Used to receive an RTP Auto
Unicast stream as input and to serve RTSP RTP clients for
output
Default = 1935. MPS Server Port for Flash VOD streams
from MPS server. Allows MPS streams as input. For example
a Vbrick H.264 encoder can be an MPS input stream.
Note: This was formerly labeled the RTMP Server Port.
Default = 5544. The port number used by the Multi-Protocol
Server to listen for announcements.
Default = 5544. Allows for listening for auto unicast sessions
from RTSP clients. Lets you send RTP streams to an RTMP
streaming server via Auto Unicast (for transmuxing to Flash,
HLS, or TS). Also allows TS streams to be served via RTSP
on this port.
Default = 8181. Specifies the listener port for HTTP
management connections as follows:
where
IPaddress
The port number can be moved to another port if required as
long as it does not conflict with another existing port in the
system.
Default = 64879. The starting port number used by the
Stream Conversion feature.
and HTTPS connections. Used for HTTPS connections
when enabled on the Security configuration page. Can be
moved to another port number if required.
.
http://IPaddress:port
= DME IP address or hostname, and port.
System Configuration
73