Ping Test - VBrick dme Admin Manual

2. Specify a size for the capture file. You can use the default or the value suggested by
Vbrick Support Services.
3. Click
Start Capture
4. Run the capture until complete or click
5. FTP to the device and navigate to the
6. The trace file will be in DME root with a name similar to this:
7. Copy the file and send to Vbrick Support Services.

Ping Test

To access the Ping Test diagnostic functions:

1. Navigate to
The ping test diagnostic utility enables you to enter a domain name or IP (IPv4) to ping
another device from the DME to make sure it may be reached.
Field
Destination
Number of Packets
Packet Size
Transmit Interval
(sec.)
Transmit Timeout
(sec.)
Ping Test Result:
Result
Response Counter
184
and confirm.
> .
Diagnostics Ping Test
Description
Domain name or IP (IPv4 or IPv6) to ping.
Default = 4. Number of packets that will be sent during the ping
test. Packet number must be a positive integer between 1 and 25.
Default = 56. The size of packet that will be sent during the ping
test. Packet size must be a positive integer between 32 and 1400.
Default = 1. The delay between each packet in the ping test.
Transmit interval must be a positive integer between 1 and 10.
Default = 5. The wait duration for each packet response in the ping
test. Transmit timeout must be a positive integer between 1 and 10.
Description
Number of packets that the host responded with under the ping
test.
at any point.
Stop Capture
folder.
trace
/trace/eth0.pcap
© Vbrick Systems, Inc.