Stream To The Dme With Rms 1.3 - VBrick dme Admin Manual

5. When done click
menu as a selectable output option.
Outputs
St re a m t o t h e D M E w i t h R M S 1.3
You can use RMS to send an H.264 unicast push or a multicast output stream to the DME.
With both methods you will need to publish the .sdp file to the DME
To configure an RMS stream for a DME:

1. Open RMS and enter a destination address on the Broadcast page. In the
field (Figure 1) enter a multicast IP address (for example 239.2.127.254) or the
Address
unicast IP address of the DME.
Note: When entering metadata (e.g. Session Info, Origin E-Mail, etc.) be sure to remove
any leading spaces.
DME Admin Guide
and and the
OK Finish H.264 for Flash
Configuring Devices for the DME
option will be added to the
Destination
203