Dme Setup - VBrick dme Admin Manual

DME Setup

1. Create a new RTP Relay. See: Create or Edit an RTP Relay.
2. Configure the RTP Relay as follows:
a. Enter a
b. Set the
Status
c. Enter the IP Address as
d. Select
Request incoming stream
e. Enter the Multicast IP Address from the .sdp file.
f. Enter the
g. Enter the Video Port value and Multicast TTL.
The user will view the video using QuickTime and entering the HTTP url to the SDP file
located on the DME. In the example above the original sdp file is
output sdp is
taco-uni1.sdp
192
.
Relay Name
to Enabled.
127.0.0.1
.
name.
Output SDP file
. So the URL will be
and enter the original .sdp file name.
taco-uni.sdp
http://172.22.2.50/taco-uni1.sdp
and the
.
© Vbrick Systems, Inc.