Configure An Hls Stream For The Dme - VBrick dme Admin Manual

Desired Result
Solution
Desired Result
Solution

Configure an HLS Stream for the DME

Desired Result
Solution
Desired Result
Solution
DME Admin Guide
Use the same TS stream to play via Flash player.
In-4 to Out1
Use the same TS stream to create a HLS stream to be played on an iPhone/
iPod touch.
to
In-4 Out-6
Generate an HLS stream from any source and have a second DME be able
to deliver the stream to its HLS clients (vice versa).
1. Generate an HLS stream: Either (
, , , or
In-5 In-1 In-4 In-7
2. Do so on both DMEs, make sure HLS names are different from each
other
3. Modify Caching Alternative Source on DME 1 to have IP address of
DME 2.
4. Modify Caching Alternative Source on DME 2 to have IP address of
DME 1.
5. The URL for both streams available in both DMEs:
http://IPofDME1/HLS/stream1/playlist.m3u8
http://IPofDME1/HLS/stream2/playlist.m3u8
http://IPofDME2/HLS/stream1/playlist.m3u8
http://IPofDME2/HLS/stream3/playlist.m3u8
Generate three different streams, coming in three separate ways, from the
same source, into a DME to create a master playlist with three streams in
reverse bitrate order so that all of them can be played on an iPad. You
should use the ideal setting for the best video/audio playable on an iPad.
1. Use same source type from encoder, not three different types.
2. Select either RTP out as
3. Use Announce Session Override in encoder to name streams
Rate1High, Rate2Mid, Rate3Low if using
4. Use the names above in the DME if using
5. Add each stream for HLS generation (
6. Use the same name for master playlist name (e.g.
them part of an adaptive set
Adaptive URL:
http://<dme_ipaddr>/dmeconfig/playlist.m3u8
Configuring Devices for the DME
to
In-3 or In-8)
) to
Out-6
; RTMP out as
IN-2 In-1
In-2
In-4
).
Out-6
to or ( ,
In-6 Out-6 In-2 In-6
; or TS out as .
In-4
or as input.
In-1
as input.
) to make
dmeconfig
207
,