In-6 < Pull (Rtsp) - VBrick dme Admin Manual

I n - 6 < P u ll ( R T SP )
In this scenario the input originates from an RTSP/RTP external source. Examples are the
server on an H.264 encoder another DME, a Wowza, QuickTime, or Darwin server.
The stream is pulled (via the RTSP session protocol) from the external source. The DME can
pull from various outside sources (e.g. from another DME, or from a Wowza, QuickTime, or
Darwin server). An RTSP Pull is configured in the DME on the
Flash Pull Settings
The stream packets are received as RTP and used as a source for any of the output protocols.
Another use of this protocol is to pull the live stream from the DME's RTP server and deliver it
as a source for one of the Multi Protocol server's output protocols or as a source for transrating.
Figure 1. Flash/RTSP Pull
Field
Type
Server:Port
DME Admin Guide
page.
Description
• RTSP – pull the RTSP stream into the DME. See In-6 < Pull
(RTSP).
• RTMP – pull the RTMP stream into the DME. See In-5 < Pull
(RTMP).
The IP address and port number of the Vbrick server. Enter a port
number only if you are not using the default RTMP port (1935) or the
default RTSP port (554).
Configure a DME Stream
>
System Configuration
51