Output Stream Configuration; Flash Push - VBrick dme Admin Manual

Output Stream Configuration

Flash Push

To access the Flash Push fields:

1. Navigate to
Use this page to configure streams that will be pushed to a destination device using RTMP.
Possible destinations for Flash push include a Flash server or a CDN (content delivery
network) like Akamai or EdgeCast.
This is the preferred protocol for sending streams to another DME. As shown below the
number of supported streams depends on the DME hardware you purchased. Note that
some fields marked with a trailing (o): these (o)ptional fields may be required at the
destination device, for example by a Wowza or other Flash server. See table below for the
number of configurable output streams.
Field
Stream Name
Target Name
Destination IP/
Address:Port
DME Admin Guide
>
Output Configuration Flash Push
Description
Name identified on the Multi Protocol input for this stream.
Stream name on the destination. When pushing to another DME it is
generally easiest to reuse the Stream Name as the Target Name.
The IP address and port number of the destination server.
Chapter 9
.
121