Create Or Edit A Vc Gateway Incoming Line - VBrick dme Admin Manual

C re a t e o r Ed i t a VC Ga t e w a y I n c o m i n g Li n e
To create or edit a VC Gateway Incoming Line:

1. Navigate to
2. Click to create a new line or
New
The
Incoming Line Details
you can use the default values which are derived from the Defaults page. Click on the
button to set or reset to the defaults.
Once a line is activated, it will automatically listen for incoming calls from the configured
video conferencing source (i.e. the
Field
Line Number
Line Name
Line Identity
Should Register
Registrar Address
Line Authentication Id
Line Authentication
Password
Never Hang Up
154
VC Gateway Configuration
Edit
page shows parameter details for the incoming line. In many cases
Line Identity
Description
Click once to select and edit any color-coded line (1–n).
New line (grey)
Connected line (green)
Not connected line (red)
User-configured line name. Default =
The DME line name and IP address in the format shown. This is
the identifier the remote videoconferencing unit will use to call
into the DME:
The session will be registered with a SIP registration server if
present. Default = Enabled.
Optional field to add the IP address of a registrar if one is
required. This field is only used to override the IP or address in
the line identity for registration.
Line Authentication Id for configured SIP registration server.
Line Authentication password for configured SIP registration
server.
Do not hang up. If you leave the call connected it will
automatically hang up after 720 minutes.
> .
Incoming Lines
to edit an existing line.
).
IncomingLine<n>
sip:<line_name>@<dme_ip_address>
Default
© Vbrick Systems, Inc.