In-5 < Pull (Rtmp) - VBrick dme Admin Manual

TS Pull supports true pass-through without any parsing of the stream so the stream and all of
its contents including KLV (if any) can be passed through to other TS destinations. See use
case Out-5 > Push TS for more information.
The incoming name specified in the user interface can now also be used to stream the
incoming transport stream as RTMP, RTP (via RTSP), or HLS. Once configured, you can see
details about this stream in the Monitor > MPS Connections page. .
Input and Output DME Streams
I n - 5 < P u ll ( R T M P )
This scenario is the same as method In-6 Pull RTSP/RTP above except that it is an RTMP
pull from an RTMP server (for example Wowza, FMS, QuickTime) or from another DME. In
this case the stream is pulled by the DME from a source with a URL similar to:
server:port/application/publishing_point.
If pulling from another DME it is convenient to make the stream name on this DME the
same as the publishing point on the source DME in order to retain the same stream name
throughout the ecosystem. The following example shows the original RTMP URL from a
VBOSS URL and the parameters on the Flash Pull Setting page from which the URL is
derived:
rtmp://fml.2D84.edgecastcdn.net/202D84/fls/2D84
Server:Port
Application
Publishing Point
Stream Name
Note that if you wish to redistribute the stream using Unannounced RTP (Out-7) Served
RTP from the RTP Server (Out-4), or Push RTP via RTSP from the RTP Server (out-11) an
internal RTP Push (Out-10) will need to be configured
To configure a pull (RTMP) input:

Objective: Pull a RTMP stream from another DME or a Flash server to redistribute.
1. In the DME, launch the management interface, log in, and go to
Flash Pull Settings
open slot from the 25 possible slots and select RTMP as the type. Enter the server IP
address or DNS host name, and enter the port if not already 1935 (default port for
RTMP). Since this is RTMP an entry in Application is required. Enter the source RTMP
server application name, for example live. Also fill in the publishing point name, which
identifies the resource on the remote system that we need to pull from. Enter a unique
stream name to be used for redistributing the stream within the DME. In most cases
there will be no need for the user name and password since this is a pull.
2. This stream can now be redistributed in several ways by the DME. It can also act as a
source for uses case Out-4 > Serve (RTP) and Out-11 > Push RTP via RTSP.
Input and Output DME Streams
50
fml.2D84.edgecastcdn.net
202D84/fls
2D84
myprogram
. You will need to pull an RTMP stream from a source, so find an
rtmp://
>
System Configuration
© Vbrick Systems, Inc.