Stream To The Dme With Rms 1.6 - VBrick dme Admin Manual

St re a m t o t h e D M E w i t h R M S 1.6
Stream to the DME with an RTP Auto-Unicast Push
To configure an RMS stream for a DME:

1. Open RMS and enter a destination address on the Broadcast page. In the
field enter the unicast IP address of the DME.
Address
2. Change the source port to a legal port number that is unused on the source RMS.
Note: When entering metadata (e.g. Session Info, Origin E-Mail, etc.) be sure to remove
any leading spaces.
Figure 1. RMS Broadcast Options (Part 1)
200
Destination
© Vbrick Systems, Inc.