Rtsp Push - VBrick dme Admin Manual

RTSP Push

To access the RTSP Push fields:

1. Navigate to
Use this page to configure streams that will be pushed to a destination device using Auto
Unicast RTP. Possible destinations include servers such as Darwin, Wowza, another DME or
a CDN. The number of configurable streams is dependent on the model of the DME.
Field
Stream Name
Target Name
Destination IP/Address:Port Enter the destination IP address. Override the Port if not
User Name
Password
Enable
Status
DME Admin Guide
>
Output Configuration RTSP Push
Description
Name identified on the Multi Protocol input for this stream.
Sets the stream name on the destination. The Target Name
has the format <TargetStreamName>.sdp. When pushing to
another DME it is generally most straightforward to reuse
the Stream Name as the Target Name.
using the default (554).
Required if client-side authentication is required by the
destination server.
Required if client-side authentication is required by the
destination server.
Default - Disabled - Enables the push.
Read only: Disabled | Streaming | Waiting for Stream (Input
source <stream_name> not yet available.)
Output Stream Configuration
.
127