Log Out Of The Dme; End User License Agreement (Eula); Register The Dme - VBrick dme Admin Manual

A typical login URL would have the following format:
http://172.22.2.50:8181
Note: Administrators should be aware that the DME's management interface is
not on Port 80 as is typical for most web-based admin tools. By default the
admin port for the DME is 8181. This allows Port 80 to be reserved for
HTTP downloads.
VBAdmin
VBDirectory
DME Status (Snapshot)
Lo g O u t o f t h e D M E
To log out of the application, click
measure, if no keyboard activity is detected for 20 minutes, VBAdmin will automatically
timeout and display the Login page.
It is highly recommended that you use the
change the user name and password after logging in for the first time. The user name and
password cannot exceed 20 characters.
En d Us e r Li c e n s e Ag re e m e n t ( EULA)
The first time you launch the DME you will need to page down and click on
This means that you accept the end user license agreement for the Vbrick software. The
application will not run if you decline to accept the EULA.
R e g i s t e r t h e D M E
Note: If you have purchased a hardware DME, it will come pre-registered
from the factory and you do not have to complete the registration steps
described in this section. These steps below are for software-only DMEs
only.
18
in the navigation panel on the left. As a security
Log Out
Username and Password
page in VBAdmin to
.
Accept EULA
© Vbrick Systems, Inc.