Configure A Multicast Relay With An Auto-Unicast Source; H.264 Encoder Setup; Dme Setup - VBrick dme Admin Manual

Configure a Multicast Relay with an Auto-Unicast Source

The Vbrick Distributed Media Engine contains a fully featured RTP server, giving the
administrator the ability to provide an RTP Relay Multicast stream. When configured, clients
will then be able to join the multicast via HTTP to the DME. This example shows how a relay
can be streamed from an auto unicast source on a Vbrick H.264 encoder.

H.264 Encoder Setup

1. Configure the encoder with a valid Auto Unicast (TCP) stream and then navigate to
Program Configuration
DME.
2. Configure the transmitter with the following settings:
a. Set the
Auto Unicast Dest Port
b. Configure the
.sdp file will be automatically placed in the root folder. (Note: The file name must be
appended with .sdp or the auto unicast will fail.)
c. Enable the transmitter and verify it is sending to the DME.

DME Setup

1. Create a new RTP Relay. See: Create or Edit an RTP Relay.
DME Admin Guide
> and configure a transmitter to unicast to the
Transmitters
to the RTSP port of the DME.
Auto Unicast Dest Pub Point Name
Detailed Use Cases
to the desired sdp file name. This
193