Configuring Devices For The Dme; Configure A Vbrick Encoder For The Dme - VBrick dme Admin Manual

Configuring Devices for the DME

The following topics explain how to configure various Vbrick devices to stream to and from
the DME.
For more information on the individual products, see the corresponding Vbrick
documentation.
All Vbrick documentation is posted on the web at www.vbrick.com/documentation. Note
that the examples in each topic refer to the drawing below.
Figure 1. Supported Input/Output Streams

Configure a Vbrick Encoder for the DME

The encoder uses cases are supported for streams from the 7000/9000 Vbrick encoders to
the DME.
Note that regardless of the way the stream is sent to DME, all output use cases are
possible. The order of this table corresponds to the recommended transport mechanisms.
Note that to maintain KLV, only Transport Stream protocols can be used (In-4, In-7,
Out-2, Out-5) The table refers to the image displayed in Figure 1 of the Configuring Devices
for the DME topic.
RTMP (Flash)
IN-8
† KLV data preserved.
DME Admin Guide
RTP TS
In-2 In-4 †
In-3 In-7
In-6
In-8
Chapter 20
197