Service Engineer Menu; Entering Invalid Engine Mode - Lexmark MB2338 Service Manual

Menu item
Scanner Configuration
Scanner Manual Registration
Front ADF Registration
Rear ADF Registration
Flatbed Registration
Scanner Configuration
Edge Erase
ADF Edge Erase
0–6 (3*)
Flatbed Edge Erase
0–6 (3*)
Scanner Configuration
Disable Scanner
Enabled*
Disabled
ADF Disabled
Scanner Configuration
Scanner Manual Registration
Print Quick Test
Scanner Configuration
Tiff Byte Order
CPU Endianness*
Little Endian
Big Endian
Scanner Configuration
Exact Tiff Rows Per Strip
On*
Off
Note: An asterisk (*) next to a value indicates the factory default setting.

Service Engineer menu

Entering Invalid engine mode

This mode allows the printer to load the correct firmware code.
1
Turn off the printer.
2
From the control panel, press and hold the 3, 4, and 6 while turning on the printer.
3
Release the buttons after 10 seconds.
Description
Manually register the flatbed and ADF after replacing the ADF,
scanner glass, or controller board.
Set the size, in millimeters, of the no‑print area around an ADF
or flatbed scan job.
Disable the scanner if it is not working properly.
Print a test page that shows the scanner margin settings.
Determine the byte order of a TIFF‑formatted scan output.
Set the RowsPerStrip tag value of a TIFF‑formatted scan output.
Service menus
183
7017-2xx, -4xx, -6xx