Installing The Enervista 469 Setup Software - GE 469 Instruction Manual

EnerVista 469 Setup Software Interface
Installing the EnerVista
469 Setup Software
GE Multilin
FIGURE 4–4: Communications using Rear Ethernet Port
The following minimum requirements must be met for the EnerVista 469 Setup
software to operate on your computer.
• Pentium class or higher processor (Pentium II 400 MHz or better recommended)
• Microsoft Windows 95, 98, 98SE, NT 4.0 (SP4 or higher), 2000, XP
• 128 MB of RAM (256 MB recommended)
• Minimum of 200 MB hard disk space
After ensuring these minimum requirements, use the following procedure to install
the EnerVista 469 Setup software from the enclosed GE EnerVista CD.
1. Insert the GE EnerVista CD into your CD-ROM drive.
2. Click the Install Now button and follow the installation instructions to install
the no-charge EnerVista software on the local PC.
3. When installation is complete, start the EnerVista Launchpad application.
4. Click the IED Setup section of the Launch Pad window.
5. In the EnerVista Launch Pad window, click the Add Product button and select
the "469 Motor Management Relay" from the Install Software window as shown
below. Select the "Web" option to ensure the most recent software release, or
http://www.GEindustrial.com/multilin
469
Motor Management Relay
4–9