Installation - GE 469 Instruction Manual

469
Mechanical Installation
Motor Management Relay

Installation

The 469 case, alone or adjacent to another SR-series unit, can be installed in the
panel of a standard 19-inch rack (see below for panel cutout dimensions). Provision
must be made when mounting for the front door to swing open without interference
to, or from, adjacent equipment. Normally the 469 unit is mounted in its case when
shipped from the factory, and should be removed before mounting the case in the
supporting panel. Unit withdrawal is described in the next section.
FIGURE 3–4: Single 469 Cutout Panel
FIGURE 3–5: Double 469 Cutout Panel
After the mounting hole in the panel has been prepared, slide the 469 case into the
panel from the front. Applying firm pressure on the front to ensure the front bezel
fits snugly against the front of the panel, bend out the pair of retaining tabs (to a
horizontal position) from each side of the case as shown below. The case is now
securely mounted, ready for panel wiring. If additional support is desired, the SR
optional mounting kit may be ordered.
808704A1.CDR
FIGURE 3–6: Bend Up Mounting Tabs
GE Multilin
3–3
http://www.GEindustrial.com/multilin