A6 Product Info; 469 Model Information; Calibration Information; Diagnostic Messages - GE 469 Instruction Manual

A6 Product Info

Table 6–3: Cause of Events (Sheet 2 of 2)
OTHER
1 TRIP Relay Forced
469 Not Inserted
Control Power Lost
Force 1 TRIP Disabled
Force 5 BLOCK Disabled
Relay Not Inserted
Simulation Stopped

469 Model Information

469 MODEL
INFORMATION

Calibration Information

CALIBRATION
INFORMATION

Diagnostic Messages

GE Multilin
2 AUX Relay Forced
5 BLOCK Relay Forced
Digital Trace Trigger
Force 2 AUX Disabled
Forced Relay
Serial Trace Trigger
Start While Blocked
A6 Product Info
PATH: ACTUAL VALUES A6 PRODUCT INFO
[ ] ORDER CODE:
469-P5-HI-A20-E
469 SERIAL NO:
MESSAGE
A3050001
FIRMWARE REVISION:
MESSAGE
4.00
BOOT REVISION:
MESSAGE
3.00
HARDWARE REVISION:
MESSAGE
H
MOD NUMBER:
MESSAGE
004
All of the 469 model information may be viewed here when the unit is powered up.
In the event of a product software upgrade or service question, the information
shown here should be jotted down prior to any inquiry.
PATH: ACTUAL VALUES A6 PRODUCT INFO
[ ] ORIGINAL CALIBRATION
DATE: Jan 01 1995
LAST CALIBRATION
MESSAGE
DATE: Jan 01 1995
The date of the original calibration and last calibration may be viewed here.
Diagnostics
Some actual value messages are helpful in diagnosing the cause of Trips, Alarms, or
Start Blocks. The 469 automatically defaults to the most important message. The
hierarchy is Trip and PreTrip messages, Alarm, and lastly, Start Block Lockout. To
simplify things, the Message LED (indicator) will flash, prompting the operator to
press the NEXT key. When NEXT is pressed, the next relevant message is automatically
displayed. The 469 cycles through the messages with each keypress. When all of
these conditions have cleared, the 469 reverts back to the normal default
messages.
http://www.GEindustrial.com/multilin
3 AUX Relay Forced
Broken Rotor Bar
Emergency Rst. Close
Force 3 AUX Disabled
Motor Started
Service Alarm
469 MODEL INFORMATION
Range: Displays the relay order code
Range: Displays the serial number of
Range: Displays the firmware revision
Range: Displays the boot software
Range: Displays the hardware revision
Range: Displays the relay modification
CALIBRATION INFORMATION
Range: month day year
Range: month day year
469
Motor Management Relay
4 ALARM Relay Forced
Control Power Applied
Emergency Rst. Open
Force 4 ALARM Disabled
No Event/Trip to Date
Simulation Started
and installed options.
the relay.
of the relay.
revision of the relay.
of the relay.
number.
6–29