GE 469 Instruction Manual page 83

Connecting EnerVista 469 Setup to the Relay
Configuring Ethernet
Communications
GE Multilin
The EnerVista 469 Setup software will display a window indicating the status of
communications with the relay. When connected, a new Site called "Quick Connect"
will appear in the Site List window. The properties of this new site cannot be
changed.
The 469 Site Device has now been configured via the Quick Connect feature for
serial communications. Proceed to Connecting to the Relay on page 4–15 to begin
communications.
Before starting, verify that the Ethernet cable is properly connected to the RJ-45
Ethernet port.
1. Install and start the latest version of the EnerVista 469 Setup software
(available from the GE enerVista CD). See the previous section for the
installation procedure.
2. Click on the Device Setup button to open the Device Setup window and click
the Add Site button to define a new site.
3. Enter the desired site name in the Site Name field. If desired, a short
description of site can also be entered along with the display order of devices
defined for the site. In this example, we will use "Pumping Station 2" as the site
name. Click the OK button when complete.
4. The new site will appear in the upper-left list.
5. Click the Add Device button to define the new device.
6. Enter the desired name in the Device Name field and a description (optional).
http://www.GEindustrial.com/multilin
469
Motor Management Relay
4–13