GE 469 Instruction Manual page 90

469
Motor Management Relay
4–20
New File Version that matches the Software Revision code from the pull-down
menu.
For example, if the software revision is 2.80 and the current setpoint file
revision is 4.00, change the setpoint file revision to "4.0X", as shown below.
Enter any special comments
about the setpoint file here.
6. When complete, click Convert to convert the setpoint file to the desired revision.
A dialog box will request confirmation. See Loading Setpoints from a File on
page 4–21 for instructions on loading this setpoint file into the 469.
f) Printing Setpoints and Actual Values
The EnerVista 469 Setup software allows the user to print partial or complete lists of
setpoints and actual values. Use the following procedure to print a list of setpoints:
1. Select a previously saved setpoints file in the File pane or establish
communications with a 469 device.
2. From the main window, select the File > Print Settings menu item.
3. The Print/Export Options dialog box will appear. Select Settings in the upper
section and select either Include All Features (for a complete list) or Include
Only Enabled Features (for a list of only those features which are currently
used) in the filtering section and click OK.
4. The process for File > Print Preview Settings is identical to the steps above.
Setpoints lists can be printed in the same manner by right clicking on the desired
file (in the file list) or device (in the device list) and selecting the Print Device
Information or Print Settings File options.
A complete list of actual values can also be printed from a connected device with the
following procedure:
1. Establish communications with the desired 469 device.
2. From the main window, select the File > Print Settings menu item.
http://www.GEindustrial.com/multilin
Working with Setpoints and Setpoint Files
Select the desired setpoint version
from this menu. The 4.0x indicates
versions 4.00, 4.01, 4.02, etc.
GE Multilin