Product Identification - GE 469 Instruction Manual

469
Motor Management Relay
WARNING

Product Identification

3–2
entry of setpoints but allow monitoring of actual values. If access to the front panel
controls must be restricted, a separate seal can be installed on the cover to prevent
it from being opened.
Hazard may result if the product is not used for its intended purpose.
FIGURE 3–2: Seal on Drawout Unit
Each 469 unit and case are equipped with a permanent label. This label is installed
on the left side (when facing the front of the relay) of both unit and case. The case
label details which units can be installed.
The case label details the following information: model number, manufacture date,
and special notes.
The unit label details the following information: model number, type, serial number,
manufacture date, phase current inputs, special notes, overvoltage category,
insulation voltage, pollution degree, control power, and output contact rating.
FIGURE 3–3: Case and Unit Identification Labels
http://www.GEindustrial.com/multilin
Mechanical Installation
Seal location
GE Multilin