Installing The Enervista 750/760 Setup Software - GE 750 Instruction Manual

750/760
Feeder Management Relay
Installing the EnerVista
750/760 Setup Software
4–12
The following minimum requirements must be met for the EnerVista 750/760 Setup
software to operate on your computer.
• Pentium class or higher processor (Pentium II 300 MHz or better recommended)
• Microsoft Windows 95, 98, 98SE, ME, NT 4.0 (SP4 or higher), 2000, XP
• 64 MB of RAM (256 MB recommended)
• Minimum of 50 MB hard disk space (200 MB recommended)
After ensuring these minimum requirements, use the following procedure to install
the EnerVista 750/760 Setup software from the enclosed GE EnerVista CD.
1. Insert the GE EnerVista CD into your CD-ROM drive.
2. Click the Install Now button and follow the installation instructions to install
the no-charge EnerVista software on the local PC.
3. When installation is complete, start the EnerVista Launchpad application.
4. Click the IED Setup section of the Launch Pad window.
5. In the EnerVista Launch Pad window, click the Install Software button and
select the "750 Feeder Management Relay" or "760 Feeder Management Relay"
from the Install Software window as shown below. Select the "Web" option to
ensure the most recent software release, or select "CD" if you do not have a
web connection, then click the Check Now button to list software items for the
750/760.
http://www.GEmultilin.com
EnerVista 750/760 Setup Software Interface
GE Multilin