Table of Contents
Advertisement
LBC-4000 L-Band Up/Down Converter System
Firmware Update
5.4.4
Steps to Complete the Firmware Update Procedure
• Chapter 6. FRONT PANEL OPERATION
• Chapter 7. ETHERNET INTERFACE OPERATION
Use the LBC-4000 front panel or the HTTP Interface to select the new firmware
image. You must then reboot the unit for the update to take effect.
5.4.4.1 Select the Boot Image
5.4.4.1.1 Use the Front Panel to Select the Boot Image
Do these steps from the LBC-4000 front panel:
1. Go to the UTILITY FIRMWARE SELECT menu branch.
Current Active Image: #2
Next Reboot Image:
2. On the bottom line, use the ◄ ► arrow keys to change to the other
image.
You must be in LOCAL MODE to perform this task. If you are not
in Local Mode (via the CONFIG REMOTE menu branch), the
unit will prompt you to take an action before continuing:
Remote Mode: press ENTER
For local mode, or CLEAR
3. You must cycle power to hard-reboot the unit.
5.4.4.1.2 Use the HTTP Interface to Select the Boot Image
Do these steps from the HTTP Interface 'Config | Utility' page:
1. Use the 'Next Reboot Image' drop-down list to select Image 1 or 2 as the
preferred Current Active Firmware Image:
2. Click [Submit].
3. Hard-reboot or soft-reboot the unit.
#1
#2
5–14
MN/LBC4000.IOM
Revision 5
Advertisement
Table of Contents
