Table of Contents
Advertisement
LBC-4000 L-Band Up/Down Converter System
MN/LBC4000.IOM
Ethernet Interface Operation
Revision 5
Converter A / Converter B
Frequency in MHz – Enter an operating RF Frequency (if the converter is a Ku-
Band down converter) in the range of 10950 to 12750 MHz; otherwise, this field
displays as N/A.
Attenuation (dB) – Enter a valid attenuation level (00.00 to 20.00 dB) in 0.25 dB
steps.
Attenuation Offset (Conv A page only): Enter a valid value, in dB, for the
attenuation offset.
Click [Change Configuration]. Click [Reset] to revert to the previously assigned
parameters (Conv B page only).
Mute
Use the drop-down list to set the Configuration Mute Mode as On or Off. Click
[Change].
Carrier Mute Mode
Use the drop-down list to set the Carrier Mute Mode as On or Off. Click [Change].
Slope
Enter a slope value (0.0 to 1.0) in 0.1 steps. Click [Change] when done.
Spectrum Inversion
Use the drop-down menu to select the Spectrum Inversion function as INV or
NRM (Normal), and then click [Change].
7–18
Advertisement
Table of Contents
