Lbc-4000 Front Panel Operations - Comtech EF Data MN/LBC4000.IOM Installation And Operation Manual

LBC-4000 L-Band Up/Down Converter System
Appendix B
• BNC connections, where applicable, use 50Ω BNC male-to-male cables.
• Comtech EF Data recommends that all Type 'N' to Type 'SMA' cable
connections are best accomplished using a Type 'N' male to Type 'SMA'
female adapter, then using Type 'SMA' female-to-female cables.
Figure B-2. LBC-4000 Rear Panel – Redundancy Cabling Schematic
See Sect. B.2 for LBC-4000 Redundancy System configuration, monitor and
control using the LBC-4000 front panel.
See Sect. B.3 for LBC-4000 Redundancy System configuration, monitor and
control using the LBC-4000 HTTP (Web Server) Interface.
See Sect. B.4 for LBC-4000 Redundancy System configuration, monitor and
control using the serial remote interface.
B.2 LBC-4000 Front Panel Operations
Figure B-3 identifies the key features of the LBC-4000 front panel. You can
configure, monitor, and control redundancy operation using the keypad and
display. Nested menus are used, which display all available options, and prompt
you to carry out a required action. See Chapter 6. FRONT PANEL OPERATION for
in-depth explanations of the function and operation of this operational interface.
B–2
MN/LBC4000.IOM
Revision 5