End Of Packet; Serial Remote Commands And Queries - Comtech EF Data MN/LBC4000.IOM Installation And Operation Manual

LBC-4000 L-Band Up/Down Converter System
Serial Interface Operation

8.2.1.7 End of Packet

• Controller-to-Target: This is the Carriage Return character {CR} (ASCII
code 13).
• Target-to-Controller: This is the two-character sequence of Carriage
Return and Line Feed {CR}{LF} (ASCII codes 13 and 10). This pairing shows
the valid end of a packet.

8.3 Serial Remote Commands and Queries

Sect. Parameter
8.3.1 AID
8.3.2 ATO
8.3.3 ATT
8.3.4 CAA
8.3.5 CAS
8.3.6 CCS
8.3.7 CMM
8.3.8 CMS
8.3.9 CUS
8.3.10 DAT
8.3.11 FBU
8.3.12 FRE
8.3.13 FRL
8.3.14 FRM
8.3.15 FRW
8.3.16 IMG
8.3.17 IPA
8.3.18 IPG
8.3.19 LAA
8.3.20 LRS
8.3.21 MAC
8.3.22 MUT
8.3.23 ONL
8.3.24 PNM
8.3.25 RAS
8.3.26 RCS
Description
Application Identification
Attenuation Offset
Attenuation Level
Clear All Alarms
Concise Alarm Status
Concise Configuration Status
Configure Mute Mode
Concise Maintenance Status
Concise Utility Status
Set Real-Time Clock Date
Force Backup
Set Operating Frequency
Fault Relay Logic
Retrieve Firmware Number
Retrieve Legacy Firmware Number
Select Boot Image
Management IP Address
Gateway IP Address
List All Alarms
Local or Remote State
Retrieve Unit MAC Address
Mute State
Online State
Retrieve Part Numbers
Retrieve Alarm Status
Retrieve Configuration Status
8–6
MN/LBC4000.IOM
Revision 5