Firmware:) InfoImage#1/#2; Firmware:) Select - Comtech EF Data MN/LBC4000.IOM Installation And Operation Manual

LBC-4000 L-Band Up/Down Converter System
Front Panel Operation
6.2.6.3.1.2 (FIRMWARE:) INFOIMAGE#1/#2
Where '#X' denotes the IMAGE#1 or IMAGE#2 firmware load, the IMAGE#1 and
IMAGE#2 firmware load info screens are nested as follows:
Use the [][] arrow keys to select Bulk, App, or FPGA. Press [ENT].
(FIRMWARE:) INFOIMAGE#1/#2BULK
(FIRMWARE:) INFOIMAGE#1/#2APP
(FIRMWARE:) INFOIMAGE#1/#2FPGA

6.2.6.3.2 (FIRMWARE:) SELECT

Use this submenu to select the Current Active Firmware Image. The read-only
top line shows the Current Active Image.
On the bottom line: Use the [][] arrow keys to select #1 or #2 as the Next
Reboot Image (i.e., the image that will be active the next time the unit is
rebooted). Press [ENT].
IMAGE#X: Bulk
Bulk#X: FW-0020503
X.X.X MM/DD/YY
App#X: FW-0020504
X.X.X MM/DD/YY
FPGA#X: FW-0020505
X.X.X MM/DD/YY
Current Active Image: #1
Next Reboot Image: #1 #2
6–20
APP FPGA
MN/LBC4000.IOM
Revision 5