Redundancy Operations Using The Lbc-4000 Http Interface - Comtech EF Data MN/LBC4000.IOM Installation And Operation Manual

LBC-4000 L-Band Up/Down Converter System MN/LBC4000.IOM
Appendix B Revision 5
B.3 Redundancy Operations Using the LBC-4000
HTTP Interface
Chapter 7. ETHERNET INTERFACE OPERATION
Use the LBC-4000 HTTP Interface 'Config | Redundancy' page to configure the
LBC-4000's Redundancy Switch Mode.
Figure B-4. 'Config | Redundancy' page
Click [Refresh] to update the page with its latest operating parameters.
Redundancy State
Use the drop-down menu to Enable or Disable LBC-4000 Redundancy, and then
click [Change] to set LBC-4000 Redundancy operation to this select status.
Redundancy Mode
Use the drop-down menu to select Redundancy Mode operation as Manual or
Auto, and then click [Change] to update LBC-4000 Redundancy operation to this
select operating mode.
B–7