Screen: 1.0.2.0 (Use Of The Digital Inputs); Screen: 1.0.3.0 (Selection Of Sensor Type And Filter For The Digital Inputs) - RMG EC 900 Operating Instructions Manual

..........................................................................................................................................................................................................

Screen: 1.0.2.0 (Use of the digital inputs)

Mod M
Mod R
Mod 3
Mod 4
Mod 5
Mod 6
Mod 7
Mod 8
<MODE INPUTS
Default values are underlined.
1) The possible selection items Totalizer, Time sync und Fault Res. are reserved for a later version of
the EC9xx and are actually not supported by the software.
Tamper c. C= anti-manipulation contact active
Tamper c. O= anti-manipulation contact as closed-circuit contact
2) Via the selection Limit contact the message "valve closed" can be transferred to the EC9xx . If a
flow rate above the creeping quantity limit is measured and the signal contact shows, that the valve
is closed, a warning is generated by the corrector.

Screen: 1.0.3.0 (Selection of sensor type and filter for the digital inputs)

Filter M
Filter R
Filter 3
Filter 4
Filter 5
Filter 6
Filter 7
Filter 8
Input M
Input R
Input 3
Input 4
<INPUT FILTERS
Default values are underlined.
3) The selection of the filters for the digital inputs 6 to 8 is not relevant, because these inputs are
actually not supported by the software.
..........................................................................................................................................................................................................
Volume input VM {Off|Totalizer}
Volume input VR {Off|Totalizer}
Digital input 3 {Off|Totalizer|Tamper c. C|Tamper c. O|
Time sync|Fault res.}
Digital input 4 {Off|Totalizer|Tamper c. C|Tamper c. O|
Time sync|Fault res.}
Digital input 5 {Off|Limit contact}
Digital input 6 {Off|Limit contact|Totalizer|Fault res.}
Digital input 7 {Off|Limit contact|Totalizer|Fault res.}
Digital input 8 {Off|Limit contact|Totalizer|Fault res.}
> "MODE INPUTS" in the "CUSTOMIZED DISPLAY" book
Frequency filter for volume input VM {Low. 50Hz|Hig. 5kHz|
Hig. 5kHz}
Frequency filter for volume input VR {Low. 50Hz|Hig. 5kHz|
Hig. 5kHz}
Filter for digital input 3 {Off|On}
Filter for digital input 4 {Off|On}
Filter for digital input 5 {Off|On}
Filter for digital input 6 {Off|On}
Filter for digital input 7 {Off|On}
Filter for digital input 8 {Off|On}
Selection of signal type for volume input VM {Reed|Namur}
Selection of signal type for volume input VR {Reed|Namur}
Selection of signal type for digital input 3 {Reed|Namur}
Selection of signal type for digital input 4 {Reed|Namur}
> "INPUT FILTERS" in the "CUSTOMIZED DISPLAY" book
1)
1)
2)
3)
3)
3)
OPERATION
61
1) 2)
1) 2)
1) 2)